Re: correct config (and syntax) for remote access

On Sun, Mar 15, 2009 at 9:08 AM, Bob McConnell <rmcconne@lightlink.com> wrote:
> P Kapat wrote:
>>
>> Host A (IP : 1.2.3.4) has the 8.1.11 postgress server running. I want
>> to set it up so that I can connect from Host B (IP 5.6.7.8).
>>
>> Relevant lines from /var/lib/pgsql/data/pg_hba.conf (on host A)
>> local   all         postgres                          ident sameuser
>> local   all         all                               ident sameuser
>> host    all         all         127.0.0.1/32          md5
>> host    all         foouser      5.6.7.8/32       md5
>>
>> Relevant lines form /var/lib/pgsql/data/postgresql.conf (on host A):
>> listen_addresses = 'localhost,5.6.7.8'
>>
>> Will this work? The firewall has 5432 port open for connection between A
>> and B.
>>
>
> Not quite. The listen_addresses should be 'localhost,1.2.3.4'. localhost is
> 127.0.0.1, which can be reached by any process on that machine. The other
> address is the TCP/IP address for the interface you want postgres to receive
> connections on. It has to be an address on the same computer as your server.
> i.e. one that shows up when you run 'ifconfig' on that box. It is probably
> easier to just use '*' unless you have multiple network interfaces.
>
> Don't forget to restart the server after you change those files.

@Peter, Bob: Thanks. I had a wrong notion of "listen_addresses"!
Everything works fine now...

One final question: Is there any "security" related difference
between, listen_addresses='localhost, 1.2.3.4' and
listen_addresses='*' that I should be aware of? There is only one
network card on the server machine, so does it matter?

--
Regards
PK
--------------------------------------
http://counter.li.org  #402424