Re: [PATCHES] snprintf causes regression tests to fail

Neither Bruce's nor subsequent Tom's patch did not fix
the issue. The command used is:

make maintainer-clean && ./configure && make && make install && make check

It should have be fine to recompile the source code
completely. I attach the resulting config.log. May be it
will give a clue. Regression test failure are in the
same places as previous ones.

Best regards,
Nicolai


On Mon, 28 Feb 2005 16:29:57 -0500 (EST), Bruce Momjian
<pgman@candle.pha.pa.us> wrote:
> Tom Lane wrote:
> > Bruce Momjian <pgman@candle.pha.pa.us> writes:
> > > Ah, the problem was introduced here:
> >
> > Right, it was my fault.
> >
> > > The problem is that the PGAC_FUNC_PRINTF_ARG_CONTROL call was moved
> > > below the printf 64-bit tests.  This commited patch moves
> > > PGAC_FUNC_PRINTF_ARG_CONTROL which is after we know AC_TRY_RUN works and
> > > just before printf 64-bit args are tested.
> >
> > This patch breaks things in a different way: you should not have moved
> > the AC_LIBOBJ(snprintf) step.  Also you randomly placed the arg-control
> > test between a chunk of code and the comment describing same.
>
> Thanks.
> --
>   Bruce Momjian                        |  http://candle.pha.pa.us
>   pgman@candle.pha.pa.us               |  (610) 359-1001
>   +  If your life is a hard drive,     |  13 Roberts Road
>   +  Christ can be your backup.        |  Newtown Square, Pennsylvania 19073
>