AW: Compile static postgres.lib for postgres 15.3 on Windows

Thanks Tom!

I also need to change the default port from 5433 to 5432 (--with-pgport=5433). How can I do this using the build.bat
toolchain?I don't see the pgport parameter in the config_default.pl file. 

Best,

Stefan

nexus / chili

Stefan Priess
Softwareentwicklung

Tel: +49 6221 18079-10
E-Mail: stefan.priess@nexus-chili.com


NEXUS / CHILI GmbH, Friedrich-Ebert-Str. 2, 69221 Dossenheim/Heidelberg
www.nexus-chili.com

Eingetragene Gesellschaft beim Registergericht Mannheim, HRB 337363
Geschäftsführer: Dr. Uwe Engelmann, Dr. Heiko Münch

-----Ursprüngliche Nachricht-----
Von: Tom Lane <tgl@sss.pgh.pa.us>
Gesendet: Freitag, 28. Juli 2023 14:48
An: Priess Stefan <stefan.priess@nexus-chili.com>
Cc: pgsql-general@lists.postgresql.org
Betreff: Re: Compile static postgres.lib for postgres 15.3 on Windows

Priess Stefan <stefan.priess@nexus-chili.com> writes:
> up to version 9.6.22 there was a win32.mak file in the src/interfaces/libpw folder which could be used to compile a
staticpostgres.lib using nmake. Since Postgres 10 this file has been removed. 

Yup.  It didn't really work right and there was insufficient interest in maintaining it.

> Is it still possilbe to build a static postgres.lib for windows ? And if so, how do I do it.

Run the normal build process using MSVC, and then just take libpq.lib from the results.  On any modern machine that's
justgoing to take a few minutes, so it's not worth maintaining a separate libpq-only build path. 

            regards, tom lane