RE: Initdb and IpcMemoryCreate Errors
От | Dave Page |
---|---|
Тема | RE: Initdb and IpcMemoryCreate Errors |
Дата | |
Msg-id | 8568FC767B4AD311AC33006097BCD3D61A2B0D@woody.vale-housing.co.uk обсуждение исходный текст |
Ответ на | Initdb and IpcMemoryCreate Errors (Dave Page <dpage@vale-housing.co.uk>) |
Список | pgsql-cygwin |
> -----Original Message----- > From: Jason Tishler [mailto:Jason.Tishler@dothill.com] > Sent: 01 May 2001 12:37 > To: Dave Page > Cc: 'pgsql-cygwin@postgresql.org' > Subject: Re: [CYGWIN] Initdb and IpcMemoryCreate Errors > > > Dave, > > On Tue, May 01, 2001 at 08:23:47AM +0100, Dave Page wrote: > > I've found the error (which probably caused my earlier > problem to continue > > longer than they needed to). In my clean installation, > cygwin1.dll is > > installed in /bin. I downloaded cygwin-1.3.1.tar.gz and > then untarred it > > over my existing installation, not realising that in the archive, > > cygwin1.dll (and some other .exes) is in /usr/bin. So all > the time I *had* > > upgraded to 1.3.1, it was just that the older .dll was in a > directory > > located before /usr/bin in the path! I've now moved the > files from /usr/bin > > to /bin, and all works fine (and uname -r proves I am > running 1.3.1 this > > time). > > I surmised that there was some kind of installation issue > that was causing > you to run a different (i.e., older) DLL than you thought > that you were. > > However, I must also point out that your installation still seems > not to be correct (or at least standard and hence supportable by the > Cygwin list). If you use Cygwin's setup.exe, then /bin and /usr/bin > are effectively the same directory due to entries in the mount table. > > For example, on my system I have the following: > > $ mount > D:\Cygwin\bin /usr/bin system binmode > D:\Cygwin\lib /usr/lib system binmode > D:\Cygwin / system binmode > ... > > The first and third entries above make /bin and /usr/bin synonymous. > > Did you use Cygwin's setup.exe? If not, then please do so in the > future. > Yes I did use setup.exe to install cygwin initially, however I used winzip to extract cygwin-1.3.1-2.tar.gz over the existing installation. Winzip of course doesn't know about cygwins mounts. OK, wrist slapped - I'll steer clear of windows programs in future! Regards, Dave.
В списке pgsql-cygwin по дате отправления: